Remove/Install Passenger Seat - Ar91.10-D-1020TSA

Model 907.6 

with code S20 (Co-driver's seat, static, folding) 

with code SH2 (Thorax/pelvis side-impact airbag, front passenger) 

with code ZU7 (National version for Canada) 

Model 907.6 

with code S20 (Co-driver's seat, static, folding) 

with code SH2 (Thorax/pelvis side-impact airbag, front passenger) 

with code ZU8 (National version for USA) 

	Risk of injury  during testing and repair operations related to pyrotechnical components	Do not expose pyrotechnical component parts to temperatures above 100 °C or 212 °F. Disconnect current supply when working on such component parts.	AS91.00-Z-0008-01A
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on carrying out repair work in the vehicle interior		AH68.00-N-0001-01S
	Information, assessment and legal requirements when working with, handling and storing pyrotechnical components		AH91.00-Z-0000-10A
	Remove/install
1	Switch off ignition and store transmitter key outside of transmission range (min. 2 m).
2	Detach ground line of on-board electrical system battery.	Before conducting any maintenance operations, switch off ignition, disconnect battery negative pole then wait for at least 3 minutes.	AR54.10-D-0029TS
3	Actuate release (1).
4	Fold seat cushion padding (2) upward.
5	Remove electrical wiring harness (3).	To do so, unclip retaining clip (4). : Check retaining clip (4) for damage. Clip remover If retaining clip (4) is damaged, replace the retaining clip (4).	Fig 1
6	Release and disconnect electrical connector (5).
7	Remove screws (6, 7) and remove front passenger seat (8).	Aid of helper required. Screw, folding front passenger seat to partition	*BA91.10-N-1011-01TS
8	Install in the reverse order.

FRONT SEATS

Fig 1: Clip Remover (452 589 01 63 00)