Perform Additional Operations When Replacing Passenger Bench Seat - Ar91.21-D-0018-01TS

Model 907.6/7 

with code U74 (Arm-rests on wall-side) 

with code U75 (Arm-rests side of gangway) 

PASSENGER BENCH SEAT

Fig 1: Long Wedge (115 589 03 59 00)

Perform next steps on old passenger bench seat.

1. Remove covers (1).

   To do so, use long wedge.

2. Remove screw/bolts (2).
3. Remove armrests (3).

   Shown on aisle side 

   Perform next steps on new passenger bench seat.

4. Open zippers (4).

   To do so, pull out zippers (4) at seat backrest frame.

5. Loosen seat backrest cover (5) in working areas.
6. Remove covers (7).

   To do so, detach seat backrest padding (6) from seat backrest frame in working areas and remove covers (7) using long wedge.

   Dispose of covers (7) properly.

   Shown on aisle side 

7. Fasten seat backrest cover (5) in working areas.

   Ensure that the seat backrest cover (5) and the seat backrest padding (6) are correctly seated.

8. Close zippers (4).

   To do so, insert zippers (4) at seat backrest frame.

9. Mark seat backrest cover (5).

   To do so, feel for edges of armrest mountings (8) and apply circular markings with a Ø of approx. 15 mm.

10. Cut into seat backrest cover (5).

    For this, apply circular cutouts (9) along previously-made circular markings using a suitable tool.

    Shown on aisle side 

11. Install armrests (3).

    It is only possible to install the armrests (3) on the seat backrest frame in one position.

12. Screw in screw/bolts (2)
13. Install cover (1).

    Shown on aisle side