Remove/Install Driver Airbag On Steering Wheel - Ar91.60-D-0663TS

Model 907 

Shown on model 907 

	Risk of injury  during testing and repair operations related to pyrotechnical components	Do not expose pyrotechnical component parts to temperatures above 100 °C or 212 °F. Disconnect current supply when working on such component parts.	AS91.00-Z-0008-01A
	Notes on carrying out repair work in the vehicle interior		AH68.00-N-0001-01S
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Information, assessment and legal requirements when working with, handling and storing pyrotechnical components		AH91.00-Z-0000-10A
	Remove/install
1	Turn steering wheel (2) to center position.
2	Detach ground line of on-board electrical system battery.		AR54.10-D-0029TS
3	Detach ground line from additional battery.	Model 907 with code E2M (Auxiliary battery for retrofitted consumers, engine compartment)	AR54.10-D-0004TSR
		Model 907 with code E2I (Auxiliary battery for retrofitted consumers, interior)	AR54.10-D-0004TS
4	Insert a Torx screwdriver T20 (6) into the access openings (3) and release the driver's airbag (1) by pushing the retaining clamps (4) one after another left and right.	Clip: Remove driver's airbag from steering wheel Angle (a) = approx. 25°. : The retaining clip (4) must latch audibly on both sides.	GB91.60-D-0000-01A
5	Remove driver's airbag (1) from steering wheel (2) until the electrical connector (5) is accessible.
6	Release and disconnect electrical connector (5) then remove driver's airbag (1).	: Ensure that electrical connector (5) is locked correctly.
7	Install in the reverse order.
	Check
8	Perform function test of horn.