Removal And Installation

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
Remove the retainers and position the fender splash shield aside.
Disconnect the wheel speed sensor electrical connector.
Remove the 2 wheel speed sensor harness bracket bolts.
- To install:
  - Tighten the bracket-to-wheel knuckle bolt to 23 Nm (17 lb-ft).
  - Tighten the bracket-to-body bolt to 7 Nm (62 lb-in).
Remove the front wheel speed sensor bolt from the knuckle and remove the wheel speed sensor.
- To install, tighten to 23 Nm (17 lb-ft).
To install, reverse the removal procedure.