Removal And Installation
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
- Remove and discard the 4 exhaust Y-pipe-to-LH and RH catalytic converter nuts.
- Discard the gaskets.
- To install, tighten to 40 Nm (30 lb-ft).
- Remove and discard the exhaust Y-pipe flange nuts and remove the exhaust Y-pipe.
- Discard the gasket.
- To install, tighten to 40 Nm (30 lb-ft).
- To install, reverse the removal procedure.
- Install new gaskets and nuts.
- Start the engine and check for exhaust leaks.
NOTE:
Always install new fasteners and gaskets. Clean flange faces prior to new gasket installation to make sure of correct sealing.