DTC Chart
WARNING: This page is about a different car, the 2011 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Some modules on this vehicle utilize a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.
DTC CHART
| DTC | Description | Source | Action |
|---|---|---|---|
| B2477 | Module Configuration Failure |
|
CARRY OUT Programmable Module Installation (PMI). REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| B2900 | VIN Mismatch |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| P0602 | Powertrain Control Module Programming Error |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| P0605 | Internal Control Module Read Only Memory (ROM ) Error |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| P1635 | Tire/Axle Out of Acceptable Range |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| P1639 | Vehicle ID Block Corrupted, Not Programmed |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| U0300 | Internal Control Module Software Incompatibility |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| U0300: 00 | Internal Control Module Software Incompatibility: No Sub Type Information |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| U0300: 51 | Internal Control Module Software Incompatibility: Not Programmed |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| U201A: 51 | Control Module Main Calibration Data: Not Programmed |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| U2050 | No Application Present |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| U2051 | One or More Calibration Files Missing/Corrupt |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| U2100: 00 | Initial Configuration Not Complete: No Sub Type Information |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| U2100: 00 | Initial Configuration Not Complete: No Sub Type Information |
|
CARRY OUT APIM programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING in this service information. |
| U2100: 56 | Initial Configuration Not Complete: Invalid/Incompatible Configuration |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| U2101: 00 | Control Module Configuration Incompatible: No Sub Type Information |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| U2101: 00 | Control Module Configuration Incompatible: No Sub Type Information |
|
CARRY OUT APIM programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING in this service information. |
| U2200: 00 | Control Module Configuration Memory Corrupt: No Sub Type Information |
|
INSTALL a new RCM . REFER to SUPPLEMENTAL RESTRAINT SYSTEM article. CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| U3000: 46 | Control Module: Calibration/Parameter Memory Failure |
|
INSTALL a new RCM. REFER to SUPPLEMENTAL RESTRAINT SYSTEM article. CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |
| U3002: 62 | Vehicle Identification Number: Signal Compare Failure |
|
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) in this service information. |