LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Merkur >> 1988 >> XR4Ti Automatic >> Repair and Diagnosis >> Engine Performance >> System >> EEC-IV System >> Quick Test >> Key On/Engine Off Self-Test >> Code Output
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Code Output

Correct test results for system are dependent on the correct operation of several related non-EEC-IV components and systems. It may be necessary to correct faults in these areas before EEC-IV will pass QUICK TEST  .

Verify that vehicle has been properly prepared. See PREPARATION  and EQUIPMENT HOOK-UP  under DIAGNOSTIC PROCEDURE  . To start SELF-TEST, turn ignition on. DO NOT  depress throttle during test. Observe and record all service codes.

  1. If engine does not start, go to CIRCUIT TEST A  step 2). If KEY ON/ENGINE OFF  code and continuous memory indicate code 11 (pass), go to TIMING CHECK  .
  2. If any KEY ON/ENGINE OFF  code is displayed with continuous memory code 11, KEY ON/ENGINE OFF SELF-TEST  indicates a fault. Record codes and see TEST RESULTS & ACTION TO TAKE  in this article.
  3. If any KEY ON/ENGINE OFF  codes or any continuous memory codes are displayed indicates a fault. Record codes, but DO NOT  repair continuous memory codes at this time. KEY ON/ENGINE OFF  and ENGINE RUNNING SELF-TEST  codes MUST be repaired first. See TEST RESULTS & ACTION TO TAKE  in this article.
  4. If KEY ON/ENGINE OFF  code 11 (pass), is displayed with ANY continuous memory code (except code 15), continuous memory indicates a fault. Record codes, but DO NOT  repair continuous memory codes at this time. KEY ON/ENGINE OFF  and ENGINE RUNNING SELF-TEST  codes MUST be repaired first. Go to TIMING CHECK  .
  5. If KEY ON/ENGINE OFF  code 11 (pass), is displayed and continuous memory code 15 is displayed, go to CIRCUIT TEST NN  , step 11). If NO CODES are displayed, repeat SELF-TEST and verify that no service codes are present. If no service codes present, go to CIRCUIT TEST NN  , step 1).