New Programming And Coding System: ISTA/P (M09 01 07)

Publication date: 2009-03-04
Reference number: M09 01 07

NEW PROGRAMMING AND CODING SYSTEM: ISTA/P

TECHNICAL SERVICE BULLETIN

Reference Number(s): SI M09 01 07, Date of Issue: March 4, 2009

MINI:	All
GROUP:	Programming/Coding Explanations

Superceded Bulletin(s): SIM09 01 07, Date of Issue: August 2008

NOTE: This Service Information bulletin supersedes SIM09 01 07 dated August 2008.

SUBJECT

New Programming and Coding System: ISTA/P

SITUATION

The Integrated Service Technical Application/Programming (ISTA/P) is the new application for:

Programming
Coding
Car and Key Memory
Conversions
Retrofits

ISTA/P runs on the Integrated Software Service Station (ISSS).

Installation and update of ISTA/P can only be performed via the ISIS server.

PROCEDURE

Any documentation about ISTA/P can be found on CenterNet - Aftersales - Portal - Service - Workshop Technology - Vehicle Programming.

The following procedures no longer apply to ISTA/P. A description of the equivalent ISTA/P procedures may be found in the CenterNet documentation described above:

General Rules for Programming

Procedure A Module Replacement

Procedure B Software Update

Procedure C Troubleshooting

Procedure E Coding