84 11 610 Removing And Installing/Replacing Eject Box (Cordless Keypad Handset)

Special tools required: 

• 00 9 322
• 00 9 341

Unlock and open storage tray (drawer).

Detach storage tray (4) as follows from function carrier:

• Release lock (3) by turning with a 1 mm feeler gauge (2).
• Pull storage tray (4) towards rear out of function carrier and set down on protective cover (1).
  Fig 1: Identifying Protective Cover, Feeler Gauge, Lock And Storage Tray

  Courtesy of BMW OF NORTH AMERICA, INC.

Press button (1) and remove SIM card holder (2).

Lever cover (3) in direction of arrow out of storage tray (4).

Fig 2: Identifying Button, SIM Card Holder, Cover And Storage Tray

Courtesy of BMW OF NORTH AMERICA, INC.

Removing:

If fitted, release catches (4) with special tool 00 9 322. 

Installation: 

Following parts of cover (7) must not be damaged or missing:

1. Catches
2. Spring
3. Release button
4. Catches
5. Guides
6. Catches
   Fig 3: Identifying Catches, Spring, Release Button, Guides And Cover

   Courtesy of BMW OF NORTH AMERICA, INC.

Using special tool 00 9 341  , unlock insert (1) and pull out slightly in direction of arrow.

Fig 4: Identifying Circuit Board, Special Tool (00 9 341) And Insert

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Remove insert (3).

Fig 5: Identifying Plug Connection, Circuit Board And Insert

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Ribbon cable (1) must be laid in guide (3).

Stop (4) and damper (5) must not be damaged.

Fig 6: Identifying Ribbon Cable, Guide, Stop And Damper

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Springs (1) must be correctly connected in mountings (2).

Catch (3) must not be damaged.

Fig 7: Identifying Hand Mirror, Springs, Catch And Mountings

Courtesy of BMW OF NORTH AMERICA, INC.