17 11 370 Removing and Installing/Replacing Cooling Loop For Power Steering

• Remove designer.
• Remove fan clutch  See 11 52 020 REMOVING AND INSTALLING OR REPLACING FAN CLUTCH (N73)
• Remove fan cowl.  See 17 11 031 REPLACING FAN COWL (N73) 
• Remove front underbody protection.

Recycling: 

Catch and dispose of hydraulic fluid.

Observe country-specific waste-disposal regulations.

Draw off hydraulic fluid.

Installation: 

Bleed power steering.  See 32 13 006 BLEEDING POWER STEERING UNIT

Unlock connection (1) on left and detach.

Fig 1: Identifying Connection On Left

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connection (1) on right and detach.

Fig 2: Identifying Connection On Right

Courtesy of BMW OF NORTH AMERICA, INC.

Remove module carrier (1) with radiator and A/C condenser from rubber mounts and push at bottom approx. 5 cm towards rear.

Installation: 

Rubber mounts fall out easily, ensure correct installation position.

Fig 3: Identifying Rubber Mounts

Courtesy of BMW OF NORTH AMERICA, INC.

Release retaining clip (1) on left.

Fig 4: Identifying Retaining Clip On Left

Courtesy of BMW OF NORTH AMERICA, INC.

Release retaining clip (1) on right.

Release screw and remove power steering cooling loop (2) towards bottom.

Fig 5: Removing Power Steering Cooling Loop & Retaining Clip

Courtesy of BMW OF NORTH AMERICA, INC.