61 31 220 Removing And Installing/Replacing Multifunction Steering Wheel Switch (From 03/2007)

WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove AIRBAG UNIT

Release screws (1).

Disconnect plug connection (2).

Remove retaining plate (3) from steering wheel.

Installation:

Make sure electrical leads are correctly routed.

Fig 1: Identifying Retaining Plate From Steering Wheel

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Illustrations depict removal of the left multifunction steering wheel switch. The right multifunction steering wheel switch is removed in the same way.

Release screws (1).

Unclip multifunction steering wheel switch (2) at point (3).

Disconnect associated plug connections and remove multifunction steering wheel switch (2).

Installation:

Make sure guide pins (4) are correctly seated.

Fig 2: Identifying Multifunction Steering Wheel Switch

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Observe the following work steps to adjust the correct gap dimensions between decorative strips and airbag unit.

Fit airbag unit (1) on steering wheel retaining plate (2)
Align switches (3)
Tighten screws (4).

Fig 3: Identifying Steering Wheel Retaining Plate

Courtesy of BMW OF NORTH AMERICA, INC.