67 64 010 Removing And Installing/Replacing Drive Unit For Electric Steering Column Adjustment

WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Move steering wheel into maximum "lower" and "extended" position
Remove DRIVER'S SIDE STORAGE COMPARTMENT

Unlock plug connections (1) and (2) of drive unit for electric steering column adjustment (3) and disconnect.

Fig 1: Identifying Plug Connections And Drive Unit For Electric Steering Column Adjustment

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

For purposes of clarity, illustrations show steering column removed.

Remove screws (1) and (2).

Installation:

Replace screws (1) and (2).

Tightening torque: 32 31 12AZ . See STEERING COLUMN for specs.

Fig 2: Identifying Steering Column Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

Pay attention to drive shafts (1) and (3) when removing and installing drive unit for electric steering column adjustment (4). Do not bend or twist.

Drive shafts (1) and (3) must be exactly inserted in associated mountings (2).

Detach drive shafts (1) and (3) from associated mountings (2) and remove drive unit for electric steering column adjustment (4).

Fig 3: Detaching Drive Shafts From Associated Mountings

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Longer drive shaft (1) is located in installation position under shorter drive shaft (2).

Drive shafts (1) and (2) must be exactly inserted in associated mountings (4).

If necessary, replace plastic mount (3).

Fig 4: Identifying Drive Shafts, Plastic Mount And Associated Mountings

Courtesy of BMW OF NORTH AMERICA, INC.