61 35 360 Removing and installing/replacing control unit for camera-based driver assistance systems (KAFAS)

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Disconnect NEGATIVE BATTERY CABLE
Remove both battery earth leads at F03
Remove trim panel for pedal mechanism. See TRIM PANEL (US ONLY) or TRIM PANEL (ECE ONLY) .

Disconnect plug connection (1).

Release screw (2).

Tightening torque 61 35 2AZ .

Pull control unit (3) out of equipment carrier (4) in direction of arrow.

Installation note:

Make sure control unit (3) is correctly installed in equipment carrier (4).

Fig 1: Pulling Control Unit Out Of Equipment Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out PROGRAMMING/ENCODING .

Carry out calibration:

Service function
Body
Display and information functions
Camera-based assist system
Calibration of lane departure warning