41 00... AFGS (active pedestrian protection) procedure after accident: Notes
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.
The AFGS system consists of the following components:
- Satellites (control unit + sensor)
- Sensors, inside, bumper trim, left/middle/right
- ACSM control unit (Crash Safety Module)
- Cables and connectors
- Engine compartment lid hinges
- Actuator
- Engine compartment lid hinge
- Engine compartment lid catch
- Catch, engine compartment lid
- Catch, upper section (striker)
In case of a frontal or side collision in the area of the engine compartment lid and/or the A-pillars, check the following components:
Satellites (control unit + sensor)
- Procedure
- Read fault memory
- Disconnect battery and observe waiting period
- Rectify faults
- Reconnect battery and observe waiting period
- Delete fault memory
- Turn off ignition and wait at least 2 minutes (no consumers may be switched on during this period such as e.g. interior lights, radio, etc.)
- Switch on ignition.
- Clear fault memory and if necessary rectify faults
Cables and connectors
- Procedure
- Check cables and connectors for damage, replace if necessary.