Airbag plug connection on gas generator/airbag module offset by 90°

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

There are two ways of unlocking this airbag plug connection on the gas generator/airbag module:

Method 1:

Simultaneously pull cover (1) upwards at lugs on left and right (2).

Fig 1: Pulling Air Bag Plug Connection Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Method 2:

Insert a narrow screwdriver into recess (1) in housing (2).

Carefully pinch cover (3) off (4).

Fig 2: Pressing Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Cover (1) is not positioned higher than housing (2).

The airbag plug connection is unlocked and can now be detached from the gas generator/airbag module.

Fig 3: Identifying Air Bag Plug Connection Cover And Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

After attaching airbag plug connection to gas generator/airbag module, press cover (1) downwards until it rests flat on housing.

Check that it catches properly.

Fig 4: Pressing Housing Cover To Downwards

Courtesy of BMW OF NORTH AMERICA, INC.