12 90... Removing and installing/replacing electronics box add-on (N63, S63, N57)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD protection)!

NOTE: Follow notes for removing and installing control units.

Necessary preliminary tasks:

Read fault memory.
Disconnect NEGATIVE BATTERY CABLE .

Release expanding rivet (1) and remove cover (2).

Installation note:

Replace damaged expanding rivet.

Holder of cover (2) must snap into place in suspension cross-brace during installation.

Fig 1: Identifying Expanding Rivet And Holder Of Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 12 90 4AZ .

Release clamp (2).

Remove cover (3) from supplementary electronics box.

Fig 2: Identifying Cover, Clamp And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip grommet hold-down device (1).

Detach rubber grommets (2) from electronics box add-on.

Installation note:

Make sure grommets are correctly seated (watertightness).

Release carrier plate (3) from lower section of supplementary electronics box (5) and set aside.

Release screw (4).

Tightening torque 12 90 2AZ .

Remove the lower section of the supplementary electronics box (5).

Fig 3: Identifying Rubber Grommets, Carrier Plate And Electronics Box

Courtesy of BMW OF NORTH AMERICA, INC.