13 62 594 Removing and installing/replacing pressure sensor on right intake plenum (N63)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Read out DME fault memory.
Switch off ignition.
Remove ELECTRONICS BOX .
Draw off A/C SYSTEM .
Secure engine in INSTALLATION POSITION .

Release screw (1).

Tightening torque 64 53 3AZ .

Detach A/C line (2) and place to one side.

Replace sealing ring on A/C line.

Fig 1: Identifying A/C Line And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and remove.

Release screws (2) with a reversible ratchet, extension, universal joint and a magnetic Torx socket.

Tightening torque 13 62 2AZ .

Pull pressure sensor (3) out of left intake plenum.

Installation note:

Coat sealing ring with lubricant.

Fig 2: Identifying Pressure Sensor, Screws And Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Delete fault memory.