31 35 007 Removing And Installing/Replacing Holder For Left Or Right Push Rod/Stabilizer

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Remove front wheel.

Remove stabilizer link from holder (1).

Release screw (2). Tightening torque, see 31 35 10AZ in 31 35 STABILIZER BAR .

Fig 1: Identifying Stabilizer Link From Holder And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Support swivel bearing with workshop jack and a suitable mounting.

Unscrew nut (1).

Remove holder (2) for brake hose, pulse generator and if necessary brake pad sensor.

Remove screw (4) with holder (3) towards front.

Installation:

Replace self-locking nut.

Tighten to specified torque. See 31 31 3AZ in FRONT AXLE -- TORQUE SPECIFICATIONS .

Fig 2: Identifying Holder For Brake Hose And Nut

Courtesy of BMW OF NORTH AMERICA, INC.