Removing and installing/replacing camera for Lane Departure Warning
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on protection against electrostatic discharge (ESD
protection).
Expand two-part mirror base cover (1) by pressing from below and detach. Feed out two-part mirror base cover (1) and remove.
NOTE:
Latch mechanisms of two-part mirror base cover (1) must not be damaged.
Slide camera (1) in direction of arrow out of mounting. Disconnect plug connection (2).
Installation note: Make sure camera (1) is firmly seated in mounting
Replacement: Carry out calibration via BMW diagnosis system. Service functions:
- Body
- Lane departure warning
- Calibrate camera
NOTE:
Heating of camera for lane departure warning is integrated in windscreen. If heating is defective, the windscreen must be replaced!