61 35 196 Removing and installing (replacing) control unit for automatic operation of tailgate system

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

DISCONNECT NEGATIVE BATTERY CABLE
Remove both battery earth leads at F03
Remove right LUGGAGE COMPARTMENT WHEEL ARCH PANEL .

NOTE: From 09/2010, the control unit is installed with a different placement of connector chambers:

control unit to 09/2010
control unit from 09/2010

Replacement:

Control unit (2) is installed as shown in vehicles with a production date up to 09/2010.

Fig 1: Identifying Control Units

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Pull out control unit for automatic tailgate activation (2) in direction of arrow.

Fig 2: Pulling Out Automatic Tailgate Activation Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out VEHICLE PROGRAMMING AND ENCODING .