April 5, 2026: LEMON Manuals is launched! Read the announcement.

86 21... Adjusting Rear Lid To Fit

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The following text describes how to adjust the rear lid to fit at one mounting point as an example. Proceed in the same way for the other mounting points.

Height adjustment of rear lid:

Release screws (1) and move rear lid in direction of arrows.

Depth adjustment of rear lid:

Release screws (2) and move rear lid in direction of arrows.

Installation:

Tightening Torque, height adjustment: Refer to 86 21 7AZ . See HOOD for specs.

Tightening Torque, depth adjustment: Refer to 86 21 9AZ . See HOOD for specs.

Fig 1: Identifying Screws

G04766454

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust gap (A) evenly all around without displacement and correct if necessary.

Fig 2: Locating Gap

G04766455

Courtesy of BMW OF NORTH AMERICA, INC.

Check lid in transition (B) to hood for displacement and correct if necessary (flush).

Fig 3: Identifying Lid In Transition To Hood

G04766456

Courtesy of BMW OF NORTH AMERICA, INC.

To align lid in transverse direction, you can install or remove plastic washers (3) between hinge bracket (1) and mounting bracket (2).

Installation:

There must always be a plastic washer (3) fitted on left and right sides of mounting bracket (2). Plastic washers are available in thicknesses of 1 mm and 3 mm.

Fig 4: Identifying Plastic Washer And Mounting Bracket

G04766457

Courtesy of BMW OF NORTH AMERICA, INC.

Check lid in transition (C) to hood (flush) and correct if necessary. Correction is made by inserting or omitting plastic washers (refer to Fig 4).

Fig 5: Identifying Lid In Transition To Hood

G04766458

Courtesy of BMW OF NORTH AMERICA, INC.