86 21... Removing Roof Railing Adapter

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Removing roof railing, refer to REMOVING ROOF RAILING

Remove molded sealing part (1).

Installation:

All molded sealing parts must rest flat on hood. Molded sealing parts are marked according to their position.

Fig 1: Identifying Molded Sealing Part

Courtesy of BMW OF NORTH AMERICA, INC.

Cut butylene tape (1) out of railing adapter (2) along dotted line (3) with a knife.

Installation:

Use butylene tape, 5 mm round, for sealing railing adapter on hood roof.

Fig 2: Identifying Butylene Tape, Railing Adapter And Dotted Line

Courtesy of BMW OF NORTH AMERICA, INC.

Railing adapters at front and rear: Release screws (1) from inside of hood. Pull out railing adapter (2) and spacer plate (3) towards bottom.

Installation:

Use new screws. Coat all screws with OKS 90 thread locking adhesive. Install spacer plate (3) in its original position.

Tightening Torque for railing adapters at front and rear: Refer to 86 21 3AZ . See HOOD for specs.

Fig 3: Identifying Railing Adapter And Spacer Plate

Courtesy of BMW OF NORTH AMERICA, INC.

Railing adapter in middle: Release screws (1) from inside of hood. Twist out railing adapter from outside.

Installation:

Use new screws. Tightening Torque for railing adapter in middle: Refer to 86 21 4AZ . See HOOD for specs.

Fig 4: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.