86 21 ... Removing Centering Pin From Mounting Bracket

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Exclusively for removal of pin, raise the hood in the GFP area. For raising, use a wooden block with a maximum width of 35 mm and a height of 45 mm. The length must be selected depending on the lifting platform securing point. Ensure the hood is secure on the blocks.

Position block (1) so that it is only located in area of sponge rubber seal (2).

Fig 1: Identifying Block & Rubber Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Insert a mandrel into hole (1) of pin (2) and turn counterclockwise.

Fig 2: Identifying Mandrel Into Hole Of Pin

Courtesy of BMW OF NORTH AMERICA, INC.