86 10 ... Removing Rear Supports And Bracket

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Release screws (1) and remove rear support (2) from bracket (3).

Installation:

Tightening Torque, refer to 86 10 PLATFORM .

Fig 1: Identifying Rear Support And Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cable holders (1) from bracket (2). Release screws (3) on left and right sides of bracket (2). Drill out rivets (4) from underside of platform. Drill out rivets (5) from upper side of platform.

Installation:

Tightening Torque, refer to 86 10 PLATFORM .

Fig 2: Identifying Cable Holders, Bracket And Rivets

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Feed cable for rear light (1) through opening (2). Fit cable holders (4) in holes (3).

Fig 3: Identifying Cable For Rear Light

Courtesy of BMW OF NORTH AMERICA, INC.