86 21 ... Adjusting Side Lid To Fit

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The following text describes how to adjust the side lid to fit at one mounting point as an example. Proceed in the same way for all other mounting points.

Height adjustment of side lid:

Release screws (1) and move side lid in direction of arrows.

Installation:

Tightening Torque. Refer to TRAILERS - TIGHTENING TORQUES - ALPINA .

Fig 1: Moving Side Lid

Courtesy of BMW OF NORTH AMERICA, INC.

Depth adjustment of side lid:

Release screws (1) and move side lid in direction of arrows.

Installation:

Tightening Torque. Refer to TRAILERS - TIGHTENING TORQUES - ALPINA .

Fig 2: Moving Side Lid

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust gap (A) evenly all around and correct if necessary.

Fig 3: Adjusting Gap

Courtesy of BMW OF NORTH AMERICA, INC.

Check lid in transition (B) to hood for displacement and correct if necessary (flush).

Fig 4: Checking Lid

Courtesy of BMW OF NORTH AMERICA, INC.

To align lid in direction of travel, you can install or remove a spacer plate (3) between mounting bracket (1) and hinge (2).

Fig 5: Identifying Spacer Plate, Mounting Bracket And Hinge

Courtesy of BMW OF NORTH AMERICA, INC.

Check lid in transition (C) to hood for displacement and correct if necessary (flush). Correction is made by inserting or omitting spacer plates (refer to Fig 5).

Fig 6: Checking Lid

Courtesy of BMW OF NORTH AMERICA, INC.