61 35 177 Removing and installing (replacing) rain/light sensor

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection ).

Necessary preliminary tasks:

Version with Autobeam:

Remove interior rear-view mirror . See 51 16 060 REMOVING AND INSTALLING/REPLACING INTERIOR REARVIEW MIRROR (OVERVIEW) .

Detach two-part mirror base cover (1) by pressing from below.

Feed out two-part mirror base cover (1) and remove.

NOTE: Catches of two-part mirror base cover (1) must not be damaged or missing.

Fig 1: Identifying Two-Part Mirror Base Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (3).

Release locks (1) in direction of arrow and remove rain/light sensor (2) from optical element.

Installation:

Do not damage optical element covered by rain/light sensor (2).

Initialize rain/light sensor.

Fig 2: Identifying Plug Connection, Locks And Rain/Light Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out vehicle programming/coding.