51 71 371 Removing And Installing/Replacing Tension Strut On Left Or Right Spring Strut Dome
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 120
For the following special tools, refer to MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS -- 128i .
IMPORTANT:
Risk of damage!
Driving without the tension strut is not permitted as otherwise the body may be damaged.
Tension strut screws must be tightened to torque and then tightened down with special tool 00 9 120 .
Driving without the tension strut is not permitted as otherwise the body may be damaged.
Tension strut screws must be tightened to torque and then tightened down with special tool 00 9 120 .
IMPORTANT:
Risk of damage!
Catch (2) and seal (3) of cover (1) must not be damaged.
Even a minimally damaged cover (1) may result in water leaking in; if necessary, replace cover (1).
Catch (2) and seal (3) of cover (1) must not be damaged.
Even a minimally damaged cover (1) may result in water leaking in; if necessary, replace cover (1).
NOTE:
Two possible versions of cover (1):
- Turn cover (with notch) approx. 45° counterclockwise
- Snap out cover (without notch) in upward direction
Remove cover (1) and release screw underneath.
NOTE:
Grommet (3) must not be pulled out of bulkhead because this eliminates the possibility of correct feeding in when installed.
Release screw (1).
Grip grommet (3) and pull out tension strut (2) in direction of arrow.
Installation:
Replace screws.
Carefully feed tension strut (1) into grommet (2).
Tighten down screws to specified torque and then retighten to angle of rotation using special tool 00 9 120 .
Tightening torque. See 51 71 2AZ SEALS AND LOOSE BODY PARTS .