61 31 020 Removing And Installing/Replacing Ignition Starter Switch
WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Move ignition lock to key position 0 (stop)
- Remove LOWER SECTION OF STEERING COLUMN TRIM
IMPORTANT:
Before removing ignition starter switch (1), secure inner shaft against turning:
Insert a M2.5* 8 screw in bore (2).
Installation:
Remove screw in bore (2).
Release screws (1), tightening torque: 61 31 1AZ . See SWITCH for specs.
Installation:
Secure screws (1) with sealing paint.
IMPORTANT:
Carefully unlock and disconnect associated plug connection for ribbon cable.
Replace the ribbon cable if damaged.
The ribbon cable leads to the CONTROL UNIT FOR THE CAR ACCESS SYSTEM .
Remove ignition starter switch (2).