61 35 132 Removing and installing/replacing central gateway module

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Disconnect BATTERY EARTH LEAD
Disconnect both negative battery cables atF03
Remove TRIM PANEL for pedal mechanism.

Disconnect plug connection (1).

NOTE: Cable shoe (4) is currently no longer installed.

If installed, release screw (2) and remove cable shoe (4).

Tightening torque 61 35 3AZ .

Pull central gateway module (3) off equipment holder (5) in direction of arrow.

Fig 1: Pulling Central Gateway Module Off Equipment Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure central gateway module (3) is correctly installed in equipment holder (5).

Replacement:

Carry out PROGRAMMING/ENCODING .

Perform FlexRay synchronization via path:

Body
Central Gateway Module
Initialize FlexRay