13 62 593 Removing and installing/replacing pressure sensor on left intake plenum (S63 B44 T 0)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Read out DME fault memory.
Switch off ignition.
Remove the engine with front axle . See 31 10 001 COMPLETELY REMOVING AND INSTALLING THE FRONT AXLE WITH ENGINE AND TRANSMISSION (S63T0, MANUAL GEARBOX) or 31 10 001 COMPLETELY REMOVING AND INSTALLING FRONT AXLE WITH ENGINE AND TRANSMISSION (S63T0, DKG) .

Release wiring harness (1) from clamps.

Disconnect plug connection (2).

Release screws (3).

Tightening torque: 13 62 2AZ

Remove pressure sensor (4).

Installation note:

Replace O-ring.

Graphic shows cylinder 5-8, procedure for cylinder 1-4 identical.

Fig 1: Identifying Pressure Sensor Wiring Harness And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Delete fault memory.