61 12... General information on intelligent battery sensor (IBS)

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not connect the charger to the 12 V charging socket
The 12 V charging socket is supplied with voltage by the rear power distribution box via relay. This relay drops out after terminal 15 OFF. This means that a trickle charger connected at the 12 V charging socket will be disconnected from the battery. Only charge the battery via the jump start terminal point. Only then can the voltage supply be registered by the vehicle.

Warning! Danger of destruction in event of mechanical strain

Do not introduce any additional connections at the battery negative terminal.
Do not modify the grounding cable. The ground cable also serves heat dissipation.
Do not establish any connection between the IBS and the sensor screw.
Do not use force when disconnecting the pole shoe from the battery terminal:
- Do not pull on the ground cable.
- Do not place any tools under the IBS to lever off the pole shoe.
Do not use IBS connections as levers.
Use a torque wrench and set tightening torque in accordance with repair instructions.
Do not release or tighten down sensor screw (Torx screw).
Avoid contact between IBS and ground.

Warning! Danger of destruction to IBS and wiring upon battery replacement

The IBS and wiring can be destroyed by mechanical strain upon battery replacement. Therefore avoid mechanical strain.
The size (capacity) of the battery required for the car is coded in the Car Access System (CAS).
Use the battery size (capacity) installed as standard upon battery replacement.
Recode the Car Access System (CAS) when installing a battery with a different capacity.
Register battery replacement via Service functions in diagnosis system.
Delete fault code entries in the Digital Engine Electronics (DME) associated with battery replacement.
Always proceed in accordance with the repair instructions.

NOTE: Battery draining possible in spite of the intelligent battery sensor IBS being fault-free.

A battery can be drained (e.g. with lights or radio switched on) even when the IBS functions perfectly in conjunction with power management.
For this reason, only replace the IBS when there is a corresponding fault entry in the DME or DDE.