52 14 ... Additional Work (Normal/Electric) With Defective Drive/Gear For Longitudinal Adjustment

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760i, 2006 BMW 760Li, and 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Seat rails must be replaced by detaching worm gear.

Move seat height and seat tilt adjustment to top position.

To obtain improved access if necessary:

Release screws (1).
Tip seat towards rear.

Installation:

Tightening torque, refer to 52 10 6AZ in SEATS - TIGHTENING TORQUES .

Fig 1: Front Seat Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Lift drive (1) and flex shaft (3) out of guide (2) in direction of arrow.

Detach flex shaft (3) (plug connection).

Fig 2: Drive, Flex Shaft, Guide And Removal Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove drive (4).

Detach flex shaft (3) with holder (2).

Fig 3: Mounting Screws, Drive, Flex Shaft And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Activate the operating switch for the seat position adjustment:

No function:
- Disconnect plug connection on drive.
- Connect new drive and check function.
- Gear is O.K. if drive runs.
  Assemble seat.
Drive running:
- Gear for longitudinal seat adjustment defective.

Removing Gear For Longitudinal Seat Adjustment:

Release screws (1).

Remove worm gear (2) on left and right with cover.

Fig 4: Mounting Screws And Worm Gear

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on upper rail on left and right.

NOTE: The seat can now be adjusted together with the upper rail.

Remove front seat. Refer to 52 14 000 REMOVING AND INSTALLING LEFT OR RIGHT FRONT SEAT (NORMAL/ELECTRIC) .

Replace both seat rails. Refer to 52 14 010 REMOVING AND INSTALLING/REPLACING BOTH SEAT RAILS ON LEFT OR RIGHT FRONT SEAT (NORMAL/ELECTRIC) .

Fig 5: Upper Rail Screws

Courtesy of BMW OF NORTH AMERICA, INC.