67 65 010 Removing And Installing Or Replacing Drive Unit For Roller Sun Blind

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove roller sun blind (refer to "REMOVING AND INSTALLING/REPLACING TRIM FOR PARCEL SHELF ")

Release screw (1).

Remove drive linkage (2).

Mark installation position of servodrive on bracket (3).

Installation:

Ensure correct cable routing.

Fig 1: Identifying Bracket And Drive Linkage

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Do not damage electrical lead for roller sun blind drive unit when drilling.

Arrange bores according to dimensions (A - D) and release screws underneath for roller sun blind drive unit.

Remove roller sun blind drive unit.

Dimensions from reference line (1):

A = 155 mm

B = 60 mm

C = 60 mm

D = 30 mm

Fig 2: Identifying Roller Sun Blind Drive Unit Drilling Dimensions

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Drive linkage (2) can only be installed in one position.

Installation:

Install drive linkage (2) and insert screw (1).

Secure drive unit to bracket (3).

Tighten screw (1).

Fig 3: Identifying Bracket And Drive Linkage

Courtesy of BMW OF NORTH AMERICA, INC.