12 14 550 Replacing control unit (DME)

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Read fault memory.
Switch off ignition
Disconnect battery
Remove LOWER SECTION OF MICROFILTER HOUSING ON RIGHT .

IMPORTANT: Follow instructions for removing and installing electronic control units

Unlock cover (1) with slide (3).

Release bolts (2).

Remove electronics box cover (1).

Installation:

Engage electronics box cover (1) correctly in hinges.

Security version:

Remove DME armour plating.

Fig 1: Identifying Electronics Box Cover And Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and detach all plug connections on DME control unit (1).

Unlock DME control unit (1) and remove.

Fig 2: Identifying DME Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Carry out CODING/PROGRAMMING .

NOTE: Read out fault memory of DME control unit.
Check stored fault messages.
Now clear the fault memory.