Vehicles with energy management systems (IBS, power module): Register battery replacement

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

The vehicle electrical system is informed about the vehicle battery characteristic data, such as type, size, age and current power capacity. Therefore, there will always be only one work scope provided that is permitted by the current status of information.

If the performance readiness drops below a defined minimum, a Check Control message will be generated to advise the driver that the battery must be replaced.

When installing a new vehicle battery, the battery must be registered and thus must also be registered with the vehicle electrical system.

NOTE: Only this registration/logon will ensure that the corresponding Check Control message will go out again.

Diagnosis system:

Service functions
Body
Voltage supply
Register battery replacement

When retrofitting, a more powerful battery may be used. Standard batteries may always be replaced by AGM batteries with the same specifications.

When installing a battery of a different size or a different battery type, this change in vehicle data must be programmed into the vehicle data in accordance with specifications.

Programming system:

Battery retrofitting