24 61 500 Transmission Control Unit

WARNING: This page is about a different car, the 2010 MINI Cooper and 2009 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Removal and Installation

Clamp off battery. See DISCONNECTING AND CONNECTING BATTERY NEGATIVE LEAD .

Release screw (1).

Detach retaining bracket (2) from control unit.

Tightening torque 24 61 1AZ .

Disconnect connector (3) and remove control unit from bracket.

IMPORTANT: The adaptation values must be reset after the control unit has been replaced.

Fig 1: Identifying Retaining Bracket With Connector And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Graphic similar.