Intelligent battery sensor
The intelligent battery sensor is secured to the negative battery terminal and connected to the Digital Engine Electronics (DME) over the local interconnect network bus.
The intelligent battery sensor is an extremely important component for energy management in the vehicle network. It is a mechatronics component for monitoring the battery condition. The following measured variables are registered:
- Terminal voltage
- Charge current and discharge current
- Temperature of the battery terminal.
Upstream processing of especially time-critical measured variables is carried out by the integrated microprocessor. The results are then forwarded to the Digital Engine Electronics (DME) via the LIN bus.
| Item | Explanation |
|---|---|
| 1 | Intelligent battery sensor |
| 2 | Battery earth lead |
| 3 | two pin plug connection |
The software in the Digital Engine Electronics (DME) controls communication with the intelligent battery sensor. Calculation of the battery condition (SOH = State of Health) and also calculation of the state of charge (SOC) is carried out in the Digital Engine Electronics (DME).
In the time between engine OFF and the switch-off of the DME main relay, the intelligent battery sensor receives the following information from the Digital Engine Electronics (DME):
- Maximum removable charge for a reliable engine start.
After switch-off of the DME main relay, the intelligent battery sensor continuously checks the state of charge and standby current consumption.