Removing and installing power distribution box (front) (Cooper Convertible)
WARNING: This page is about a different variant/trim than selected.
WARNING:
,
Comply with NOTES for disconnecting and connecting the vehicle battery and
INSTRUCTIONS on intelligent battery sensor (IBS).
Observe and follow SAFETY INSTRUCTIONS for handling vehicle battery.
,
Comply with NOTES for disconnecting and connecting the vehicle battery and
INSTRUCTIONS on intelligent battery sensor (IBS).
Preliminary work needed:
- Remove TRIM for bottom right dashboard.
- Remove right GLOVE COMPARTMENT with housing.
Removal:
Remove screw (1).
Feed out power distribution box (2) from support (3).
Installation:
Feed in power distribution box (2) into support (3).
Tighten screw (1).
Tightening torque 61 14 3AZ .
Required follow-up work:
- Install right GLOVE COMPARTMENT with housing.
- Install bottom right INSTRUMENT PANEL TRIM .