April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removing and installing/replacing the convertible top module (Cooper Convertible)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Observe NOTES on protection from electrical damage (ESD protection).

Preliminary work needed:

Remove rear right SIDE TRIM PANEL .

Removal:

Unscrew nuts (1).

Remove the equipment holder (2).

G12677510

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock detents (1).

Pull out the convertible top module (CVM) (2).

G12677511

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect the connector (1) on the convertible top module (CVM) (2).

G12677512

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Connect the connector (1) to the convertible top module (CVM) (2).

G12677512

Courtesy of BMW OF NORTH AMERICA, INC.

Join the convertible top module (CVM) (2) with the equipment holder.

NOTE: Check the detents (1).

G12677511

Courtesy of BMW OF NORTH AMERICA, INC.

Join the equipment holder (2).

Tighten down nuts (1).

G12677510

Courtesy of BMW OF NORTH AMERICA, INC.

Preliminary work needed:

Install the rear right SIDE TRIM PANEL .

Replacement:

Carry out ENCODE/PROGRAM