Technical Description (Comment)
CAUTION:
If the ignition switch is turned to the ON position without starting the engine, DTC (past trouble) 017 and 018 may be set on the combination meter (incorporating meter-ECU) after three minutes.
Current trouble
- Connector(s) or wiring harness in the CAN bus lines between the powertrain control module and the combination meter, the power supply system to the powertrain control module, the powertrain control module itself, or the combination meter may be defective.
Past trouble
- Carry out diagnosis with particular emphasis on connector(s) or wiring harness in the CAN bus lines between the powertrain control module and the combination meter, and the power supply system to the powertrain control module. For diagnosis procedures, (Refer to HOW TO USE TROUBLESHOOTING/INSPECTION SERVICE POINT
).NOTE: For a past trouble, you may not find it by the MUT-III CAN bus diagnostics even if there is any failure in CAN bus lines. In this case, refer to HOW TO COPE WITH INTERMITTENT MALFUNCTIONS ). and check the CAN bus lines. You can narrow down the possible cause of the trouble by referring to the DTC, which is set regarding the CAN communication-linked ECUs (Refer to EXPLANATION ABOUT THE SCAN TOOL (MUT-III) CAN BUS DIAGNOSTICS ).