LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2006 >> Lancer Evolution >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycle Procedures >> 2011-12 OUTLANTER 3.0L >> Pattern 9 >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

  1. Start the engine with all the accessories switched OFF.
  2. Drive the vehicle for 5 minutes at the following condition. (During the monitor)
    • Vehicle speed: More than 50 km/h (31 mph)
    • Air flow rate: More than 12 g/sec
    • Except fuel cut
  3. Stop the vehicle in a safe place and let the engine idle for 30 seconds.
  4. Turn the ignition switch to "LOCK" (OFF) position.
  5. Confirm that the diagnostic trouble code (DTC) is not output.
scientia non olet · About LEMON Manuals