LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2007 >> Raider SE >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Electronic Control Modules >> Module - Powertrain Control >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module - Powertrain Control: Installation

CAUTION: Certain ABS systems rely on having the Powertrain Control Module (PCM) broadcast the Vehicle Identification Number (VIN) over the bus network. To prevent problems of DTCs and other items related to the VIN broadcast, it is recommend that you disconnect the ABS CAB (controller) temporarily when replacing the PCM. Once the PCM is replaced, write the VIN to the PCM using the DRB scan tool. This is done from the engine main menu. Arrow over to the second page to "1. Miscellaneous". Select "Check VIN" from the choices. Make sure it has the correct VIN entered before continuing. When the VIN is complete, turn off the ignition key and reconnect the ABS module connector. This will prevent the setting of DTCs and other items associated with the lack of a VIN detected when you turn the key ON after replacing the PCM.
CAUTION: Use the DRB scan tool to reprogram the new PCM with the vehicles original identification number (VIN) and the vehicles original mileage. If this step is not done, a Diagnostic Trouble Code (DTC) may be set.
Fig 1: Identifying PCM, PCM Mounting Bolts And Ground Strap
G04853428Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Position PCM (3) to vehicle.
  2. Install three PCM mounting bolts (2).
  3. Tighten bolts to 3.5 N.m (30.40 in. lbs.).
    Fig 2: Identifying Powertrain Control Module (PCM)
    G04853426Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Be sure ground strap (4) is secured both at bottom of PCM, and at inner-fender.
  5. Check pin connectors in the PCM. Also check the four 38.way connectors (2) for corrosion or damage. Repair as necessary.
  6. Install the four 38.way connectors (2) to PCM.
  7. Connect negative battery cable.
  8. Use the diagnostic scan tool to reprogram new PCM with vehicles original Identification Number (VIN) and original vehicle mileage. If this step is not done, a Diagnostic Trouble Code (DTC) may be set. 
scientia non olet · About LEMON Manuals