LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2007 >> Raider SE >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Engine Electrical >> Battery Cables >> Installation >> Positive
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Battery Cables: Installation: Positive

Fig 1: Identifying Nut, Cable, Integrated Power Module (IPM), Terminal Clamp And Stud
G04854922Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Position the battery positive cable (4 and 8) in the vehicle.
  2. Install the nut (5) securing the cable to the Integrated Power Module (IPM) (7) stud (6). Tighten the nut to 11.5 N.m (105 in. lbs.).
  3. Install the nut (3) securing the cable (4) to the alternator. Tighten the nut to 14 N.m (125 in. lbs.).
    Fig 2: Identifying Starter Solenoid Wire Harness Connector, Left Frame Rail And Battery Cable Retaining Pushpin
    G04854917Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Install the cable pushpin (5) into the left frame rail (4).
  5. Connect the starter solenoid wire harness connector (1).
    Fig 3: Identifying Cable, Nut And Starter Solenoid
    G04854918Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  6. Raise the vehicle on a hoist, (Refer to GENERAL/HOISTING/STANDARD PROCEDURE ).
  7. Install the nut (2) securing the cable (1) to the starter solenoid (3). Tighten the nut to 13 N.m (115 in. lbs.).
  8. Connect the battery cable retaining pushpin (6) securing the cable to the engine block.
  9. Lower the vehicle.
    Fig 4: Identifying Nut, Cable, Integrated Power Module (IPM), Terminal Clamp And Stud
    G04854916Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  10. Connect the battery positive cable terminal clamp (8). Tighten the battery terminal clamp pinch-bolt hex nut to 5 N.m (45 in. lbs.).
    Fig 5: Identifying Air Inlet Tube, Clamp, Bolts And Air Intake Resonator
    G04854915Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  11. Position the resonator (4) into the vehicle. Install the bolts (3) into the air intake resonator (4) and tighten the band clamp (2) on the air inlet tube (1).
  12. Connect the battery negative cable terminal clamp. Tighten the battery terminal clamp pinch-bolt hex nut to 5 N.m (45 in. lbs.).
  13. Check the vehicle for normal operation.
scientia non olet · About LEMON Manuals