Timing Chain Learned Value Reset
WARNING: This page is about a different car, the 2019 Mitsubishi Mirage G4. However, it is still accessible from the selected car via links, so may be relevant.
Required Special Tools:
- MB992744: Vehicle communication interface-Lite (V.C.I.-Lite)
- MB992745: V.C.I.-Lite main harness A
- MB992747: V.C.I.-Lite USB cable short
- MB992748: V.C.I.-Lite USB cable long
- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicles Communication Interface (V.C.I.)
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A (Vehicles with CAN communication system)
CAUTION:
To prevent damage to scan tool (M.u.T.-iii), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
- After the ignition switch is in "LOCK" (OFF) position, connect scan tool (M.U.T-III) to the data link connector.
- Turn the ignition switch to the "ON" position.
- Select "MFI" form System select Screen of scan tool (M.U.T.-III).
- Select "Special Function" form MFI Screen.
- Select "Timing chain maintenance" from Special Function Screen.
- Select "Learned value reset" form Timing chain maintenance Screen.
- Press "ON" to reset the learning value.