Data Monitor Mode
NOTE:
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to M.U.T.-III SE display items.
| Monitor item | Unit | Remarks |
|---|---|---|
| Steering torque | Nm | Displays steering torque detected by power steering torque sensor. |
| Demanded motor current | A | Displays the current value demanded by EPS motor. |
| Assist level | % | Displays the current percentage of the allowable assist ratio EPS motor. |
| EPS warning | Displays the EPS system warning status. | |
| Demanded assistance torque | Nm | Displays the assist torque of EPS motor being output by the power steering control module. |
| Measured motor current | A | Displays the current value consumed by EPS motor. |
| ECU temperature | °C | Displays the temperature of the power steering control module. |
| Battery voltage | V | Displays the power supply voltage for power steering control module. |
| Auto stop start status | - | Displays but not used. |
| Vehicle speed | KPH | Displays the vehicle speed. |
| ENGINE STATUS | Status1/Status2/Status3 | Displays the engine status. |
| Auto stop start sub-sys mode | - | Displays but not used. |
| Filter | - | Displays but not used. |
| Battery disconnect count | - | Displays the count of disconnected 12V battery terminal. |