Diagnosis Procedure

1. Electric motor switch OFF, and then wait for 3 minutes with driver door open.
   NOTE:

   • Even after electric motor switch is OFF, power is supplied to accessories for a certain amount of timer by the AUTO ACC function  .
   • When vehicle is operate while on standby, power may be supplied to accessories  .
2. Check that the following fuse is not blown (open).

   Fuse No.	Current rating
   52	20 A

Is the fuse blown (open)? 

YES: Repair the blown (open) fuse after repairing the affected circuit if a fuse is blown (open).

NO: GO TO  2.

1. Disconnect front power window motor (driver side) connector.
2. Turn the power supply mode of the electric motor switch to ON.
3. Check voltage between front power window motor (driver side) harness connector and ground.

   (+)		(-)	Voltage
   Front power window motor (driver side)
   Connector	Terminal
   D10	4	Ground	10 - 16 V

Is the inspection result normal? 

YES: GO TO  3.

NO: Repair or replace harness.

1. Turn the power supply mode of the electric motor switch to OFF.
2. Check continuity between front power window motor (driver side) harness connector and ground.

   Front power window motor (driver side)		-	Continuity
   Connector	Terminal
   D10	3	Ground	Existed

Is the inspection result normal? 

YES: INSPECTION END

NO: Repair or replace harness.