LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 1995 >> Maxima GLE, RE4F04A >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests 3.0L >> Fuel System >> Fuel Pump System Test >> Federal Emissions
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Federal Emissions

  1. Turn ignition on. With fingers, pinch fuel feed hose at fuel filter. Fuel pressure pulsation should be felt for 5 seconds after ignition is turned on. If pulsation is not felt, go to next step. If pulsation is felt, system is functioning properly.
  2. Turn ignition off. Disconnect fuel pump relay. Fuel pump relay is located on left kick panel. Turn ignition on. Measure voltage between ground and fuel pump relay harness connector terminals No. 1 (Brown wire) and No. 3 (Black/White wire). Battery voltage should be present. If battery voltage is present, go to next step. If battery voltage is not present, check 10-amp and 15-amp fuses in fuse box. Check harness continuity between fuses and fuel pump relay. Repair or replace as necessary.
  3. Turn ignition off. Disconnect fuel pump harness connector (in trunk). Check continuity between fuel pump relay harness connector terminal No. 5 (Black/Yellow wire) and fuel pump harness connector terminal No. 1 (Black/Yellow wire).
  4. Also check continuity between fuel pump harness connector terminal No. 2 (Green/Red wire) and ground. Continuity should exist in both checks. If continuity exists in both checks, go to next step. If continuity does not exist in either check, repair appropriate harness or connectors.
  5. Ensure ignition is off. Disconnect ECM harness connector. ECM is located under center of instrument panel (connector is on driver's side). Check continuity between ECM harness connector terminal No. 11 (Black/Pink wire) and fuel pump relay harness connector terminal No. 2 (Black/Pink wire). Continuity should exist. If continuity does not exist, check harness between ECM and relay. Repair harness and connectors as necessary.
  6. If continuity exists, check fuel pump relay. See RELAYS  under RELAYS & SOLENOIDS. Also check fuel pump. See FUEL PUMP  . If necessary, replace fuel pump relay or fuel pump. If fuel pump relay and fuel pump are okay, disconnect and inspect harness and connectors for pushed-out, bent, damaged or corroded terminals. Repair harness or connectors as necessary.
scientia non olet · About LEMON Manuals