LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1110 (Rear Final Drive) >> Rear Final Drive Assembly >> Disassembly and Assembly >> Disassembly >> Removal of Electric Controlled Coupling Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal of Electric Controlled Coupling Assembly

WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the drive pinion flange wrench, Remove companion flange lock nut.

    Tool number: KV38108300 ( - ) 

  2. Using the puller, remove the companion flange.
  3. Remove coupling cover.
  4. Using flat tip screwdriver, remove Front oil seal from the coupling cover.
    CAUTION: Be careful not to damage the coupling cover.
    Fig 1: Removing Front Oil Seal From Coupling Cover
    G00768564Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Remove electric controlled coupling assembly from the gear carrier.
  6. Using a puller, remove coupling front bearing from the electronically controlled coupling.
    CAUTION: When the bearing is replaced with new one, reassemble the shim between bearing and the coupling.
    Fig 2: Removing Coupling Front Bearing From Electronically Controlled Coupling
    G00768565Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals