Combination Meter Self-Diagnosis Mode Functions
WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
To interpret combination meter self-diagnosis mode functions, refer to the following table.
SELF-DIAGNOSIS MODE FUNCTIONS CHART
| Event | Odometer Display | Description of Test/Data | Notes: |
|---|---|---|---|
| Odometer/trip meter A/B switch held from 5 to 8 seconds (or until released) | tESt | Initiating self-diagnosis mode | |
| Switch released | GAGE | Performs sweep of all gauges, then displays present gauge values. | Gauges sweep within 10 seconds |
| Switch pressed | (All segments illuminated) | Lights all LCD segments. Compare with picture. | |
| Switch pressed | bulb | Illuminates all micro-controlled lamps/LEDs. | Part may not be configured for all lamps (functions) that turn on during test. This is normal. |
| Switch pressed | r XXXX, FAIL | Return to normal operation of all lamps/LEDs and displays "r XXXX". | If a malfunction exists, "FAIL" will flash. |
| Switch pressed | nrXXXX | N/A | |
| Switch pressed | EE XX, FAIL | Displays "EE XX". | If a malfunction exists, "FAIL" will flash. |
| Switch pressed (4 times) | DtXX through Epr XX | N/A | |
| Switch pressed | 1nF XX | Displays 8-bit market info value in Hex format. | $31 = USA $2A = Canada |
| Switch pressed (3 times) | cYL XX through tF | N/A | |
| Switch pressed | XXXXX | "Corrected" speed value in hundredths of MPH. Gauge indication may be slightly higher. This is normal. | Will display "-" if message is not received. Will display "99999" if data received is invalid. |
| Switch pressed | XXXXX | "Corrected" speed value in hundredths of KPH. Gauge indication may be slightly different. This is normal. | Will display "-" if message is not received. Will display "99999" if data received is invalid. |
| Switch pressed | t XXXX | Tachometer value in RPM. Gauge indication may be higher at higher RPM. This is normal. | Will display "-" if message is not received. |
| Switch pressed | F1XXXX | Present fuel level A/D input. This input represents fuel sender input. | 000-009 = Short circuit 010-254 = Normal range 255 = Open circuit |
| Switch pressed | F2XXXX | "Filtered" fuel level. Fuel gauge indicates present filtered level per indication standard. | 000-009 = Short circuit 010-254 = Normal range 255 = Open circuit |
| Switch pressed | XXXC | Last temperature gauge input value in degrees C. Temperature gauge indicates present temperature per indication standard. | Will display "-" C if message is not received. Will display "999" if data received is invalid. High = 130 deg C Normal = 70 - 105 deg C Low = less than 50 deg C |
| Switch pressed | BAtXXX | Estimated present battery voltage. | |
| Switch pressed | rES-X | Seat belt buckle switch LH status. | 1= Buckled 0 = Unbuckled |
| Switch pressed (31 times) | PA -XX through PA1-XX | N/A | |
| Switch pressed | GAGE | Return to beginning of self-diagnosis cycle. |