Power Supply and Ground Circuit Check for AV Switch

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FUSE

Make sure the following fuses of the AV switch are not blown.

FUSE REFERENCE

Terminals		Power source	Fuse No.
Connector	Terminal	Power source	Fuse No.
M98	1	Battery power	3
M98	2	ACC power	6

OK or NG

OK: GO TO 2.

NG: If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse. Refer to "POWER SUPPLY ROUTING CIRCUIT ".

CHECK POWER SUPPLY CIRCUIT

Disconnect AV switch connector.

Check voltage between connector terminals and ground as follows.

POWER SUPPLY CIRCUIT

Terminals			Ignition switch position
(+)		(-)	OFF	ACC	ON
Connector	Terminal	(-)	OFF	ACC	ON
M98	1	Ground	Battery voltage	Battery voltage	Battery voltage
M98	2	Ground	0V	Battery voltage	Battery voltage

Fig 1: Checking Voltage Between Connector Terminals And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 3.

NG: Check harness for open between AV switch and fuse.

CHECK GROUND CIRCUIT

Turn ignition switch OFF.

Check continuity between AV switch and ground as follows.

GROUND CIRCUIT

Terminals			Continuity
(+)		(-)
Connector	Terminal	(-)
M98	5	Ground	Yes

Fig 2: Checking Continuity Between AV Switch And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Inspection End.

NG: Repair or replace harness.